INSTALLATION

Our in installation experts are bonded insured and licensed. Contact us for any plumbing installation today!

LEAK DETECTION

Our leak detection experts have years of experience in leak repairs. You can depend on us for any plumbing Santa Ana needs.

WATER HEATER

We are experts in water heater repair, maintenance and installation. Count on us for all your water heater needs.

BATHROOM & SHOWER

We are well-skilled in bathroom and shower repairs, maintenance and installation.
Call us up today!

As a homeowner, knowing a myriad of different toilet problems and solutions can go a long way. A clogged toilet and leaking perhaps become two of the most common problems that many homeowners have to face. What’s worse is, they are not the only problems that many homeowners may have to face at least once in their lives.

Types of Common Toilet Problems You May Find

With such understanding, you will be able to diagnose toilet problems you have at hand. With your assessment, you will find out whether or not the issue can be fixed on your own. After all, there are some issues you cannot easily patch up on your own, whereas others may require immediate attention from an expert. Below is a list of problems homeowners may encounter.

  • Toilet flush problems

toilet fill valve One of the common problems homeowners may run into is a weak flusher. Understanding what may be the cause of this seemingly simple issue can be a challenge, mostly because there is a large variety of circumstances that may affect your flusher. However, most of the time, this issue is caused by your toilet plumbing or an old, broken down 1.6-gallon flush toilet.

  • Toilet fill valve problems

You may encounter a problem with your toilet tank where it’s filled with water as if the toilet has just been flushed. The common culprit of this particular problem is either improper sealing on the flapper front, or leaking in your tank. More often than not, this problem can be easily dealt with by replacing the valve.

  • Toilet flush valve problems

toilet valve flush

Flapper valve must remain at about 80-percent or more of the total water that has been drained from the tank. When it fails to stay at the aforementioned level, your flapper valve may be dropping at a faster than normal rate. Or, worse, it may be waterlogged. When you are dealing with this particular problem, installing a new flapper becomes the only available solution.

  • Toilet bowl problems

toilet bowl

We have encountered this issue at least once in our lives. It started nothing out of ordinary, we flushed the toilet and everything seemed to work perfectly. However, after some time, we started noticing that rather significant amount of water left the toilet bowl. This shouldn’t have happened in the first place, and there are two possibilities why toilet drainage problems could happen.

The first possibility is that the water was initially siphoned by a partial clog. Said partial clog more often than not can be found in the colon of toilet bowl. Regardless of what object clogging the colon, the water in your toilet bowl is slowly siphoned – causing a massive drainage. In worse but rare cases, there may be a crack right in the piping of the bowl or its interior colon. In such case, bowl replacement is needed.

Another toilet related problem is leaking around the base of your toilet. In many cases, a leak around the toilet signifies major plumbing issues. It’s the primary reason a professional must be called in to help determine the cause of leaking. With toilet leak detector, our experts will find the answer in no time. Perhaps your toilet just needs to be replaced, but it’s always better to be safe than sorry.

Clogged Toilet Problems and Repair

clogged toilet

It’s an unsettling fact, but most toilets do clog at one time or another. When your toilet is clogged, more often it’s due to your own impatience trying to flush too much all at once. However, one of the most common causes can be traced back to low water pressure. When the water pressure is low, it will undoubtedly fail to deliver enough force to move materials.

Although it can be quite nasty, typically there is no need to call in a professional plumber. Yes, among other issues, homeowners can easily manage fixing clogged toilet on their own. However, before we get started on the tutorial, it’s worth noting that there are some items that cannot be flushed. In such case, a help from professional plumber is needed.

To start this clogged toilet repair step-by-step tutorial, first you must gather the things you need. For this repair mission, you will need a bucket, a plunger, rubber gloves, and a closet auger. Now, grab your plunger and be sure to check if your toilet bowl is empty before you start. If it’s empty, fill the bowl with water until it completely covers the plunger – but don’t start yet!

If you are not sure about your plunging skill, don’t worry, there is virtually no wrong way to do it. However, if this is your first time, we have a few useful tips. The first plunge is the only time for you to go easy as the plunger’s bell is filled with air. If you push too hard the first time, the seal will force the air back resulting in water blown all over you.

Once the air has been pushed out and the seal has been formed around its trap, you may start plunging straight down forcefully. Next is, pull your plunger all the way back toward your toilet tank, all while maintaining the seal. During this stage, always watch the water in the toilet bowl. Remember that your plunger must always be covered in water as it generates the pressure needed to loosen clogs.

Repeat the straight down plunge followed with a pull-back toward the tank movement until you draw out the problem material. However it’s worth noting that in some clogged toilet drain cases, you must switch to using closet auger to get the job done. Additives may also be required if said problem material is that of un-flushable items.

Call 714.987.2670

Common Types of Toilet Leaks

toilet paper

The moment you see water on the bathroom floor, you most likely cannot help but being concerned about your finding. More often than not, the problem lies in the seal that lines up the toilet with sewer line. However, there is always a possibility of it being wastewater making its way from beneath the toilet. Knowing the many types of common toilet leaks will undoubtedly give you a peace of mind.

Determining where the leaking is located can be quite complicated. However, you may do so by using organic-based food coloring. Here we are going to talk about the types along with a step-by-step tutorial on how to fix it. Let’s start from the base. Keep in mind that, if water backs up from down the line, said wastewater must not go further past the wax ring.

However, when it comes to the point where your toilet basin leaking, chances are the issue is more than worn-out wax ring. Replacing your toilet’s wax ring may be a good step to take. But it most likely won’t solve the issue at hand. This is the case that belongs to the professionals, because giving you a tip on how to fix a leaking toilet base may likely end up in drainage problems. Contact us now for help.

  • Tube

Think your toilet tube leaking? This common problem is typically started by minor dripping that escalates when left untreated. When this happens, your toilet simply won’t work as normally, so there is definitely no mistaking it. In the case of toilet overflow tube leaking, the common sign includes water flooding the toilet bowl. Fixing this issue is quite simple as you only have to replace the tube.

  • Pipe

When it comes to leaking toilet pipe, you may have quite a work to do as it’s quite difficult to locate. However, there are about four common leak locations you can assess first.

One of the common locations is the waste pipe. In this case, you may skip the ABS plastic lines as it typically isn’t the culprit. It’s the cast-iron waste lines that need repairing as it’s prone to punctures and cracks. To fix this leaking toilet waste pipe kerfuffle, repair the damaged line and patch up the concrete.

  • Seal

Toilet wax ring leak can be source of headache. However, it’s actually fairly easy to manage on your own. When you find a leak on the base of your toilet, the issue is typically referred to as toilet wax seal leak. Simply because the wax-sealant has worn out and needs replacing. Toilet seal leaking is perhaps no longer a horror when you know how to fix it.

To start your leaking toilet seal repair quest, start by draining the water and removing your toilet. Lift it up, remove its mounting bolts around it, and thoroughly clean the remaining of old wax surrounding the area. Once finished, plug the toilet’s drainage with old towel to avoid sewer gas from surfacing. Check its flange for any puncture or cracks and install repair parts before setting everything back up.

  • Pump

Toilet seal leaking can also be traced back to your pump. When you are dealing with this issue, you can do the following steps to fix the issue. To do this, simply tighten the fixing you can find between its body parts. You may not be able to see the source of this toilet pump leaking, but don’t fret. Once finished, remove the toilet’s inspection cover and proceed to tighten its diaphragm nut.

  • Valve

Another common toilet fill valve leaking issue can also be found in the supply line of your toilet. To investigate the issue, assess if there is leaking toilet valve. When your toilet inlet valve leaking, you must first check for water-dripping from the nuts. You may find it on both ends of your toilet’s supply line. Said line attaches the shut-off valve with fill valve.

Toilet float valve leaking can also happen due to rigid supply line. To fix this problem, you may try to replace the toilet’s supply washers. Are you considering which type of supply line to install? We highly recommend water flexes made of flexible stainless steel. The nature of this material makes it one of the most reliable options that is easier to attach. Better yet, it also avoids toilet water valve leaking.

There are quite a few toilet issues such as the toilet drain leak, toilet reservoir leaking, toilet stopper leaking, and toilet water line leaking. Most of these issues can be traced back to its flappers. When the flapper is not installed properly, it’s unable to form a tight seal against the toilet’s valve seat. This issue may also appear when the flapper is worn out and needs a replacement.

Call 714.987.2670

Importance of Toilet Flapper

toilet flapper

If you are looking for a simple yet effective toilet flapper repair method, chances are you are currently dealing with toilet flapper leaking. The method largely depends on which area of problem you are facing at present. It may be in the tank, valve, and even seal. In order to find out how to do it, simply follow the step-by-step process we have listed below.

  • Leaking toilet tank flapper

You can easily spot the flapper chain from your toilet’s flush handle lever. Find a small-sized clip at the top of said chain and simply undo the clip. To replace your flapper, slip its side-ears from the sides of your flush-valve tube and off the pegs. Then it’s only a matter of setting up your flapper so it goes with the design of your toilet. Put it into place, connect the chain, and secure them once properly adjusted.

  • Toilet tank fill valve leaking

Is it your fill-valve that needs attention? You may have probably read the step-by-step process above in the previous section. Scroll up to learn more about how to do it. Don’t be intimidated as it’s incredibly simple to do on your own. Last but not least is the seal. Step-by-step process on toilet tank seal replacement can also be found in the previous section.

Navigate Your Way around Toilet Bowl and Flush

toilet bowl flush

Your toilet has the ability to run constantly due to its moving parts. Many homeowners are unaware of the each of the parts that come with their toilet. The toilet bowl parts, for example. This seemingly simple part of the toilet is enough to give them a headache. Homeowners often question how toilet bowl is running, what the importance of toilet bowl valve is, and why their toilet is dripping into bowl.

The latter is typically followed with a question about whether or not water trickling into toilet bowl is normal. Knowing it’s something out of the ordinary, many scramble for tips on toilet bowl repair, hoping they can fix it. While water leaking into toilet bowl cannot be considered normal, it’s actually easy to repair.

However it’s worth noting that the only exception is when the issue is not quite about water leaking out of toilet bowl, but rather, the toilet bowl leaking from base. Finding a leak on the base of your toilet bowl may be challenging task. More so when you don’t have the words nor do you have to harness a particular skill-set on doing that.

Another common issue typically appears when we encounter problems such as toilet not flushing, toilet will not flush, toilet flush broken, and toilet flush not working. While the before mentioned list may not cover other issues surrounding them. However, this is not to say that you are doomed. With this article, you will find a way on how to fix toilet flush.

The moment you notice that your toilet leaking when flushed only or perhaps toilet flush leaking water, you may be worried. It’s most likely followed with questions regarding how to fix toilet flush and toilet repair flush valve. While toilet flush repair may not be difficult to do, the same cannot be said for toilet flush valve leak. The degree of difficulties typically stem from how complex it can be to determine.

When you suspect the source of your problem is your flush valve, immediately check on either the canister valves or chain. How to repair toilet flush is extremely simple as very often, it’s due to disconnected chain. With that being said, all you have to do is reattach the chain. How about toilet not flushing all the way? This is typically the result of a chain that is too short.

If that is not the case, check the canister part of the toilet. A valve located in said canister is most likely sticking in a certain way that leads to its abnormally open position. Most of the issues surrounding the flush typically rotate in its valve and chain. So it’s relatively easy to figure out and fix.

A Professional Help Just One Call Away

toilet flushDespite your best efforts in following our toilet tank repair pointers above, there still comes a time where replacing a toilet cannot be avoided. Perhaps your toilet is just too old and problematic that you cannot seem to get it to work as it should. Although our experts swear by our step-by-step tutorial on how to fix a leaking toilet tank, severe condition cannot be fixed with toilet tank leak repair.

In some cases, you only have to grab some toilet replacement parts and do partial replacement such as replacing toilet seal, replacing toilet pipe, toilet pump replacement and toilet tank replacement. While all of that can easily be done on your own, sometimes you need professional help to assist you through it.

In that case, you are advised to call in a plumbing service for sensitive cases such as toilet insides replacement and complete toilet installation.

Call 714.987.2670

TESTIMONIAL

I don’t know how to express my appreciation to Santa Ana plumbers. They’re quick and professional. On top of that they are always on time. I have recommended the same with my neighbors. You will surely appreciate this company of good plumbers. They are the real deal in plumbing!
-- Alison, Santa Ana --